SMOK G-PRIV 2 With TFV8 Big Baby Starter Kit W/O Battery
Product Introduction
SMOK G-PRIV 2 Starter Kit is powered by dual external 18650 batteries (not included) so that the G-PRIV supports max 2w wattage. The big 2.4″ TFT touch screen and screen lock button will simplify vaping operation. And the lateral big fire key provides you with good hand feel and smooth visual effect. You can operate the G-PRIV 2 just like using a smart mobile phone. TFV8 Big Baby works well with G-PRIV 2 and forms up G-PRIV 2 kit. The G-PRIV 2 kit will bring better vaping experience to you.
Features
2.4″ super touch screen
2W output power
Shatter-resistant screen
Upgradeable screen locked button
Virtual up/down button
Delrin drip tip
Adjustable airflow system
Parameters
SMOK G-PRIV 2 Box Mod
Size: 85 x 58.5 x 28mm
Voltage Range: 0.35 – 8V
Power Range: 1 -2W
Resistance Range: 0.1 -3ohm (VW) / 0.06 -2ohm (TC)
Temperature Range: 0℉–600℉/100℃–315℃
Battery: dual 18650 batteries (not included)
SMOK TFV8 Big BABY Tank
Size: 24.5 x 56mm
Capacity: 5ml
Material: SS
Thread: 510
It comes with
- 1 x G-PRIV 2 MOD
- 1 x TFV8 Big Baby Tank
- 1 x V8 Baby-X4 Core (pre-installed)
- 1 x V8 Baby-T6 Core
- 1 x Replacement Glass Tube
- 1 x USB cable
- 1 x User Manual
- Spare parts
Simple packing. Customary packing from the factory, the packing is subject to change without notice.
Operation Guide
How to fill e-Juice:
- 1. Hold the tank with one hand, and use another one to press top cap and move it clockwise.
- 2. Add e-liquid through the slot, and pay attention not to drip in the central airflow;
- 3. Close the cap carefully and firmly. Then let it stands for several minutes to get the organic cotton completely saturated.
How to build the RBA:
- 1. Before starting make sure your hands are clean.
- 2. Taking RBA deck apart.
- 3. Installing and positioning the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.
- 4. Cutting the ends of wire off.
- 5. Cutting a strip of cotton and make sure it’s not too much and not too less.
- 6. Inserting the cotton, and placing it in the middle.
- 7. Cutting the cotton at an angle and make sure it’s not too short and not too long.
- 8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.